20
S T E P
5
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 5B. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
5A.
Attach U Bracket
(S)
& Handle Bar
(R)
to Carriage
(J)
in the
sequence shown in the Step 5 Drawing using:
1 - (#4) M10x20mm Hex Head Bolt
1 - (#8) M10 Large Washer
1 - (#10) M10 Lock Washer
2 - (#5) M8x20mm Button Head Cap Screw
2 - (#11) M8 Washer
2 - (#12) M8 Lock Washer
2 - (#30) Metal Bushing
1 - (#31) Torsion Spring
NOTE #1:
- Assembling the U Bracket Assembly (S) will require a torque pre-load on
Torsion Spring (31).
- Insert the straight dog-ear of the Spring (31) into the hole on the bracket
of the Seat Frame (J).
- Slide the left side of the U Bracket Assembly (S) into the j-hook end of
the Torsion Spring (31).
- As you slide Handle Bar (R) into place, you will need to push on the body
of the Torsion spring to align with shaft pushing through.
- Drawing shows the Assembled View of the U-Bracket & Handle Bar.
5B.
Attach Shaft
(#32)
to U Bracket
(S)
using:
2 - (#5) M8x20mm Button Head Cap Screw
2 - (#15) M8 Large Washer
2 - (#12) M8 Lock Washer
Summary of Contents for GCLP100
