14
S T E P
3
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 3D. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
3A.
Attach Upper Uprights
(E)
to Lower Upright
(D)
using:
4 - (#4) M10x95mm Hex Head Bolt
8 - (#9) M10 Flat Washer
4 - (#11) M10 Nylon Lock Nut
3B.
Attach Medicine Ball Tray
(F)
to Upper Uprights
(D)
using:
4 - (#5) M10x60mm Hex Head Bolt
8 - (#9) M10 Flat Washer
4 - (#11) M10 Nylon Lock Nut
3C.
Attach Top Medicine Ball Tray
(G)
to Upper Uprights
(D)
using:
4 - (#5) M10x60mm Hex Head Bolt
8 - (#9) M10 Flat Washer
4 - (#11) M10 Nylon Lock Nut
3D.
Attach Logo Plate
(H)
to Upper Uprights
(D)
using:
4 - (#5) M10x60mm Hex Head Bolt
8 - (#9) M10 Flat Washer
4 - (#11) M10 Nylon Lock Nut
Summary of Contents for GAR250
