10
5
S T E P
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until end of step 6.
S T E P
5
Be careful to assemble all components
in the sequence they are presented.
A. Connect Seat Pad (M) to Mainframe (A) by using:
One A11 (M8x80 hex head bolt)
One A7 (M8x100 hex head bolt)
Two C4 (M8 spring lock washer)
Two C3 (M8 washer)
B. Insert End Caps (D2) to ends of Back Pad support (F).
C. Connect Plastic Sleeve (D3) to Mainframe (A) as shown in the diagram. Insert End Cap
into the end of Back Pad Support (F).
D. Slide Back Pad Support (F) through Mainframe (A) as shown in the diagram.
E. Connect Back Pad (N) to Back Pad Support (F) by using:
Two A8 (M8x50 hex head bolt)
Two C4 (M8 spring lock washer)
Two C3 (M8 washer)
F. Slide Pad Wrap onto Back Pad (N).
14
mm
Inch
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1"
2"
3" 4"
5"
6"
