Setting/Service Guide
37
calibration procedure:
1)
Remove the safety key
2)
Press and hold down the
incLine
and
SpeeD
buttons with one hand and replace
the safety key with the other. Continue to hold both keys until the window displays
“
FactORY Setting
”, then press the
enteR
key.
3)
You will now be able to set the display to show English or Metric settings. To do this,
press
Up/DOWn or FaSt/SLOW
keys to show which you want, then press
enteR
.
4)
Make sure the wheel size diameter is 2.98 then press
enteR
.
5)
Adjust the maximum speed (if needed) to 12.0mph or 20.0kph and then press
enteR
.
6)
Adjust the minimum speed (if needed) to 0.5mph or 0.8kph and then press
enteR
.
7)
Message Windows will show “
incLine
StepS
“. Adjust the maximum elevation (if
needed) to 15 and then press
enteR
.
8)
Message Windows will show “
caLibRatiOn On
“. Press
StaRt
to begin
calibration. The process is automatic; the speed will start up without warning, so do
not stand on the belt. After finishing calibration, it automatically returns to
iDLe
mODe.
adjusting the speed sensor:
If the calibration does not pass you may need to check the speed sensor alignment.
1)
Release motor cover screws (screws are not necessarily taken apart) and remove
the motor cover hood.
2)
The speed sensor is located on the left side of the frame, right next to the front roller
pulley (the pulley will have a belt around it that also goes to the motor). The speed
sensor is small and black square with a wire connected to it.
3)
Make sure the sensor is as close as possible to the pulley without touching it. You
will see a magnet on the face of the pulley; make sure the sensor is aligned with
the magnet. There is a screw that holds the sensor in place that needs to be
loosened to adjust the sensor. Re-tighten the screw when finished.
Resetting cumulated distance and time (DIAGNOSTICS PROCESS):
1)
Remove the safety key and press numeric key
0
and
enteR
then return the safety
key to enter displaying the version of cumulated distance and time. Total time is
shown on window TIME while total mileage and software version on window MW.
2)
To clear the value, press numeric keys
7 → 8 → 9 → 7
hen press
enteR
key to
reset total mileage and time to zero.
3)
Press
StOp
key to exit and return idle mode.
