48
T
T
R
R
O
O
U
U
B
B
L
L
E
E
S
S
H
H
O
O
O
O
T
T
I
I
N
N
G
G
G
G
U
U
I
I
D
D
E
E
CODE
REASON
SOLUTION
E1
Message failure between
computer and bottom control
board
1. Check the computer and bottom
control board wire connect well.
2. Check if IC on bottom control board
is loosen, reset the IC.
3. Power on bottom control board has
some problem, change the bottom
control board.
E2
Burst clash
1. Check the power is right, if not, use
correct power to test.
2. Check if the bottom control was
burnt out, change a good one;
reconnect the motor wire.
E3
No sensor signal
1
.
Check the speed sensor wire
connect well, reconnect the wire.
2
.
Check if the speed sensor was
damaged, change a good one.
E4
Incline Error
1. Check the incline motor wire
connect well, reconnect the wire.
2. Check if the incline motor was
damaged, change a good one.
E5
Current overload protecting
1
.
Over rated loaded or the motor is
stuck, cause excessive current,
machine will start self-protecting
system. Adjust the machine and
restart.
2
.
Check if the motor has noise from
motor or if the motor / bottom
control board were burnt out, if
burnt out, change good motor and
bottom control; Use right voltage.
E8
Driver Problem
1
.
Check if the 24C02 8 pin IC in the
bottom control board connect well,
reconnect it.
2
.
Change the bottom control board
Summary of Contents for BT-5405P
