BRF980 BRF855
Page 15
Assembly STEP 8
Remove two
D Shape Washers (#24)
, two
Washers (#46)
,
two
Spring Washers (#47)
, two
Bolts (#45)
and two
Wavy
Washers (#48)
that are pre-assembled on the
Main Axle (#20)
.
Set them aside nearby.
Insert the
Main Axle (#20)
through the
Main Frame(#01)
,
making sure the
Main Axle (#20)
is centered. If you encounter
too much friction, try using WD40 or Vaseline as a lubri
Next, on the right side, slide one
Wavy Washer (#48)
on
Main
Axle (#20)
followed by
Right Handlebar (#09R)
and secure
with one
D Shape Washer (#24)
, one
Washer (#46)
, one
Spring Washer (#47)
and one
Bolt (#45)
.
Repeat this process on the left side using
Left Handlebar (#09L)
.
Carefully cut off the zip tie on the
Bushing (#22)
of the
Right Linkage (#10R)
. With the help of an assistant, on the right
side as shown in drawing below, insert one
Bolt (#64)
through
one
Washer (#68)
, the
Right Handlebar (#09R)
followed by the
Bushing (#22)
of
Right Linkage (#10R)
. Secure these together
from the other “inner” side of
Right Linkage (#10R)
using one
other
Washer (#68)
and one
Nylon Nut (#69)
. Repeat this pro-
cess on the left side with the
Left Handlebar (#09L)
.
Hardware Required
#20.Main Axle
[1 Piece]
Pre-assembled
#45.Bolt
(M10x20 mm)
[2 Pieces]
#64.Bolt
(M8x42 mm)
#69.Nylon Nut (M8)
#68.Washer (M8)
[4 Pieces]
#24.D-Shape
Washer
[2 Pieces]
Pre-assembled
#46.Washer (M10)
Pre-assembled
#47.Spring
Washer (M10)
Pre-assembled
#48.Wavy
Washer (M16)
[2 Pieces]
Pre-assembled
[2 Pieces]
[2 Pieces]
Pre-assembled
[2 Pieces]
[2 Pieces]
