BRT5008
Page 8
Assembly STEP 2
Remove the Nylon Nuts
(#27)
,Washers
(#33)
and Wavy Washers
(#82)
that are pre-assembled on the Handlebar Axle
(#20)
and set
them aside as they will be used later in this step.
Insert the Handlebar Axle
(#20)
through the main frame. Make
sure the Handlebar Axle
(#20)
is centered. If you encounter too
much friction, try using WD40 or Vaseline as a lubricant.
Then attach one Wavy Washer
(#82)
on each side of the Handle-
bar Axle
(#20)
. Attach Left Coupler Bar
(#09L)
and Right Coupler
Bar
(#09R)
to the main frame via the Handlebar Axle
(#20)
. Again,
use WD40 or Vaseline to reduce friction if needed. Once the Left
Coupler Bar
(#09L)
and Right Coupler Bar
(#09R)
are correctly
situated, fasten the end of the Handlebar Axle
(#20)
with a Washer
(#33)
and a Nylon Nut
(#27)
on each side. Then cap each end
with a Bolt Cap
(#34)
.
Note:
Make sure Left /Right Coupler Bar
(#09L/09R)
are at the correct side when its horizontal pivot tube, which is
welded at the top, faces the REAR of the machine as seen from the user
Hardware Required
#20
Handlebar Axle
[1 piece]
Pivot Tube
(see note below)
#27
Nylon Nut (M10)
[2 pieces]
#34
Bolt Cap (S17)
[2 pieces]
#33
Washer
(M10)
[2 pieces]
#82
Wavy Washer
[2 pieces]
82
82
Summary of Contents for Trio Trainer BRT5088
Page 2: ...This page is left blank intentionally ...
Page 3: ......
