BRT5800/3980
Page
13
Assembly STEP 7
Hardware Required
Attach
Backrest Cushion Tube (#07)
to the
Seat Cushion Tube
(#08)
and secure by using two
Hex Bolts (#28)
, two
Spring Washers
(#41)
and two
Washers (#40)
.
With the help of an assistant, align the two holes of the
Rear Handle
Bar (#10)
to the holes on the
Backrest Cushion Tube (#07)
and
secure all using the two
Hex Bolts (#26)
, followed by two
Arc
Washers (#39)
, two
Washers (#40)
, and two
Nylon Nuts (#37)
.
Slide the
Seat Cushion Tube (#08)
onto the trough of the
Seat Post
(#09)
as shown below. Secure using two
Lock Knobs (#48)
through
two
Washers (#78)
.
then loosen the
Spring Loaded Knob (#46)
and pull back slightly on
it so that you may proceed to insert the
Seat Post (#09)
assembly
into the opening of the post that is protruding from the
Main Frame
(#01)
down a minimum of four inches so that the corresponding holes
can engage. Screw in the
Spring Loaded Knob (#46)
through the
Main Frame (#01)
and then through any one of the holes located on
the
Seat Post (#09).
Note: The
Spring Loaded Knob (#46)
has a safety feature that
allows you to loosen it by turning it counter-clockwise three times
as you pull it outward. This knob can be loosened to adjust the seat
height. Adjust the seat height and then release the knob back in.
Tighten the knob by turning clockwise.
#28 Hex Bolt (M8 x 20mm)
[2 pieces]
#26 Hex Bolt (M8 x 45mm)
[2 pieces]
#78 Washer (M10)
[2 pieces]
#39 Arc Washer (M8)
[2 pieces]
#41 Spring Washer (M8)
[2 pieces]
#40 Washer (M8)
[4 pieces]
#48 Lock Knob (M10)
[2 pieces]
#37 Nylon Nut (M8)
[2 pieces]
#46 Spring Loaded Knob (M16)
[1 piece]
Secure the
Spring Loaded Knob (#46) to the Main Frame (#01),
Removed the two
Washers (#78)
and two
Lock Knob (#48)
that are
pre-assembled on the
Seat Cushion Tube (#08)
. Set them aside as
they will be used later in this process.
