INSTALLATION INSTRUCTIONS
Page 2 of 3
5.
Select (1) 14mm Double Nut Plate. Insert the Nut Plate into the end of the driver/left side frame
channel,
(Figure 5)
. Line up the hex nuts on the Nut Plate with the large slots in the side of the
frame,
(Figure 6)
. Repeat to insert the remaining Double Nut Plate in the passenger/right side
of the frame.
6.
With assistance, carefully position the Rear Bumper Assembly up to the outside of the frame.
Use the provided (2) 14mm x 40mm Hex Bolts, (2) 14mm Lock Washers and (2) 14mm Flat
Washers to attach the Bumper to the 14mm Nut Plate inside the driver/left frame channel,
(Figure 7)
. Reuse the (2) factory bolts to attach the Bumper to the outside of the frame,
(Figures 7 & 8)
. Leave hardware loose. Repeat this Step to attach the passenger/right side of
the Bumper to the outside of the frame
.
7.
Level and adjust the Rear Bumper and tighten all hardware at this time.
8.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment
, do not use any type of polish or wax that may contain abrasives that could damage the
finish. Mild soap may be used to clean Bumper
(Fig 3) Remove tow hook and outer bumper
bracket from driver/left side of frame (arrows)
Rear
Rear
(Fig 2) Remove (2) outer bumper bracket bolts
(Fig 1) Remove (2) hex bolts attaching
bottom of bumper to frame cross member
Rear
(Fig 4) Attach Block Off Plate or light (available
separately) to tabs on back of Bumper (optional)
Tab for light
