3 Series Dual Row LED Cube
Lights(Fog Beam)
Part Number 30034
Installation
Thanks to its on-board controller and included wiring harness, the Cube Lights do
not need any additional wiring or plugs. Diagram for the wiring harness can be seen
below. Feed the black connector on the harness to the light bar and plug in. Route
the black and red power wires towards the battery. Secure the power relay in place
using either a screw or a zip tie. To ensure longevity of the relay, mount in the
upright position with the metal mounting hole facing up. This will prevent water
from sitting near the electrical components. Locate the ON/OFF switch in a
convenient location.
