Bodin 22.352409.01.001, Instruction Manual

Page: 12 / 38

Instruction manual
12
Air filter
• The air filter should be cleaned once every two weeks.
• Open the air inlet grille and take off air filter.
• Clean the air filter with neutral detergent in lukewarm 40°C water
and allow to dry (not in direct sunlight).
• Re-install the air filter into the inlet grille.
TROUBLESHOOTING
Troubles Possible Causes Suggested Remedies
The unit does not start
when pressing power
button. • Water full indicator
lamp blinks and water
tank is full.
• Room temperature is
higher than the
setting temperature.
(Electric heating
mode)
• Room temperature is
lower that the setting
temperature.(Cooling
mode)
• Drain the water out of
the water tank.
• Adjust the
temperature.
The unit doesn’t cool
enough. • The doors or windows
are not closed.
• There are heat
sources inside the
room.
• Hot air exhaust hose
is not connected or
blocked.
• Temperature setting
is too high.
• Air inlet in blocked.
• Make sure all the
windows and doors
are closed.
• Remove the heat
sources if possible.
• Connect or clean the
hot air exhaust hose.
• Reset the
temperature.
• Clean the air inlet.
Auto Power-Off in heating
mode. • Heating protection,
when the temperature
at the air outlet
exceeds 70 degrees,
the unit will power off
automatically. • Allow room
temperature to cool
before re-starting the
unit.
Noisy. • The ground is not
level or not flat
enough.
• The sound comes
from the flowing of the
refrigerant inside the
air conditioner.
• Place unit on a flat,
level ground if
possible.
E0 Code. • Room temperature
sensor failed. • Replace room
temperature sensor.
E3 Code • Pipe temperature
sensor failed. • Replace pipe
temperature sensor.
E2/E4 Code. • Water tank full • Please empty the
water tank.