b
Press [+] until the required minute is displayed. To synchronise your clock to the nearest
second, select the current 1 and as the minute pips, validate by pressing [SEL] ;
The internal second counter is then reset to zero and starts up.
3. a
a Having validated the minutes : the year flashes.
b
Press [+] until the current year is displayed.
4. a
Validate the year by pressing [SEL] : the month flashes.
b
Press [+] until the required month is displayed.
5. a
Press [SEL] to validate the month : the day flashes.
b
Press [+] until the chosen day is displayed (Scrolling of the days
takes account of the month and year selected (leap years)).
6.a
To conclude time setting, press the [SEL] button.
Caution :
At any time by holding down [SEL] then :
pressing [+] quickly, will return you to normal display mode.
pressing [+] for longer (more than 3 seconds), will take you to the
configuration menu.
If no buttons are pressed for a period of over 10 minutes, the clock automatically returns to
normal time display mode.
4.2 Radio synchronised Clock
If the quality of reception is good, the time on the clock will be set automatically. In zones
where the radio signal is difficult to receive, clock can be set on time manually, following the
procedure described in the previous chapter.
4.3 AFNOR or impulses slave Clock
The time on the AFNOR/Irig-b slave clock will be set automatically.
After a reset or a time setting, the clock search each minute, during 20 seconds, until it get
synchronised.
Minute or ½ minute slave clocks must be set to the time of time distribution network.
Remark : See the chapter “Technician Menu” page 44 to parameter to time distribution.
Caution :
In case of no AFNOR synchronisation message :
-
After powering up the clock, no time will be displayed and the clock will show two dots.
-
It is always possible to modify the time setting but the time will not be running and the
cock will only display the two points.
32
