30
Normal operation of the shot clock keyboard
1/ Press START / STOP (1) to satrt the countdown of the shot clock.
Press again to stop the countdown.
At the end of the countdown (when the possession time reaches 0)
a sounding signal is started for a duration of 3 seconds.
The LED of the keyboard turns red when the shot clock is
stopped and green when the shot clock is counting down.
2/ Pressing the RESET 24s (2) or RESET 14s (8) key for few
seconds causes the shot clock LED panel and the LCD display
of the keyboard to turn off (blank). The initial value of the timer
(24 sec or 14 sec depending on which key was pressed) is
restored when the key is released.
3/ Pressing the CLEAR (3) key causes the keyboard LCD display
to show - - and the shot clock panel to blank. Pressing this key
again allows the displaying of the current countdown value without
affecting the running of the timer.
4/ Pressing the HORN (4) stops the horn when its is blown
automatically when the countdown reaches 0.
This key does not
turn on the horn.
Modify the current possession time
1/ Press the START / STOP (1) key to stop the timer.
2/ Press the C (6) key.
The LCD display and the led of the keyboard start blinking.
3/ Press the PLUS + (5) key to increment by 1 second the current possession time.
This value cannot exceed the stored RESET value (24 sec by default).
4/ Press the MINUS - (7) key to décement by 1 second the current possession time.
5/ Press the C (6) key again to go back to the normal mode.
Recover possession time
1/
If the RESET 24s (2) key is pressed by mistake then press the CLEAR (3) key within the following
2 seconds to recover the previous time.
Modify the preset value of the possession time (default: 24 seconds)
1/
Press the START / STOP (1) key to stop the possession time timer.
.
2/
Hold down the CORRECTION (6) key of the possession time keyboard for 3 seconds
.
The Shot clock displays and the keyboard LCD display are blinking. The value displayed is the currentRESET value
.
3/
Press the + (5) key to increment the current RESET value (99 sec. max.)
.
4/
Press the - (7) key to decrement the current RESET value
.
5/
Press the CORRECTION (6) key to come back to normal mode
l.
This parameter is not saved in case of a power failure or if the keyboard is unplug at the end of the game.
Luminosity adjustment of BT6002 display
1/ Press the + (5) key during 3 seconds.
2/ Press the + (5) key to increase the luminosity.
3/ Press the - (7) key to decrease the luminosity.
4/ Press the C (6) key to go back to normal mode.
No backup of this parameter, if the power is cut or when unplugging the keyboard at the end of the match.
4
1
2
3
6
5
7
8
4
1
2
3
6
5
7
8
