8
Control System Instruction
Power switch
: Plug in, press
for 3 seconds to turn on or off the unit.
button ;Press
to change the temperature display between Celsius and Fahrenheit.
Lock button
:Press
for 3 seconds to lock the control panel except light button, press
this button again once need to unlock the control panel.
button : The temperature will increase 1ºF or 1ºC if you push the
button , the
temperature will decrease 1ºF or 1ºC if you push the
button.
Light button
:Press
to turn on or off.
Setting The Temperature Controls
You can set the temperature as you desire by pushing the “+”or “-”button. When you push the
two buttons for the first time, the LED readout will show the original temperature set at previous
time.
The temperature that you desire to set will increase 1ºC/1
℉
if you push the “+” button once, on
the contrary the temperature will decrease 1ºC/1
℉
if you push the “-” button once.
Model
Temperature range
JC-58A/JC-85A/JC-145A
The temperature setting can be adjusted from 5
℃
/41
℉
to 20
℃
/68℉.
The temperature preset at the factory is 12
℃/53.6℉.
Attention
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restart
the unit. If you attempt to restart before this time delay, the Wine Cellar will not start. If first time
use or longer absence of using, the temperature will be different between setting and LED
display temperature. After running a period, the temperature will be reverting back.
Shelves
To prevent damaging the door gasket, make sure to have the door all the way opened
when pulling shelves out of the rail compartment.
For easy access to the storage content, you must pull the shelves approximately 1/3 out of
the rail compartment, however this unit was designed with a notch on each sides of the
shelf tracks to prevent bottles from falling.
Please refer to the following direction for replace shelf with different method.
If need to take out any shelf,
use one hand to press down the right plastic notch as
shown in Figure A and at the same time lift the left plastic notch by other hand as
shown in Figure B. Hold both notches and then proceed to pull out the shelf slowly.
Contact our service department if assistance is needed.
