Steel frame Table form lift TL 1512
213300043
77
8.3 Transport of material
Set switch position to “Außen” (Outside), remove key
During this operating mode the transport of personnel is prohibited.
A pendant control panel is used to operate the platform from the
ground station or from the load position control, if available.
1.
As soon as the platform comes to a complete halt, open the loading position gate ad
the platform gate.
2
Load the platform.
CAUTION!
Poorly secured material is inherently dangerous and can cause personal injuries.
Secure the material properly and prevent slipping and sliding. Avoid parts
protruding over the edge of the platform.
3
Close and lock platform and loading position gates.
4
Activate the applicable travel direction
(UP/DOWN)
on the pedant control panel or on the
loading point control system.
Stop - at
next floor
NOTE!
While in the 2 m area,
only the pendant control panel
in the ground station
can be used to operate the platform. Chapter 6.1.1 page 59)
As soon as the platform has left the 2 m area of the ground station, and after
pressing the applicable travel direction button, the control system of the
Table lift is locked.
Before reaching target floor, briefly press this button during the travel.
(see Chapter 59 page )
5.
The platform stops automatically at the next floor.
6.
First, open the hinged ramp of the platform, then the loading position gate and finally the
platform gate.
7.
Load or unload the platform.
8
First, close the platform gate, then the loading position gate and finally the hinged ramp.
