BOC Edwards A343-10-940, Instruction Manual

Page: 46 / 48

E1M18 and E2M18 Rotary Vacuum Pumps
SERVICE, SPARES AND ACCESSORIES
PAGE
40
Issue L 40 Sep 06
7.4 Accessories
7.4.1 Introduction
A range of accessories is available for the E1M18 and E2M18 pumps, as shown in Figure 12.
The accessories are briefly described in the following sections. Refer to Table 11 for the Item Numbers
of these accessories.
7.4.2 Inlet Catchpot
The Inlet Catchpot traps any liquid droplets and prevents their entry into the pump.
7.4.3 Inlet Dust Filter
The Inlet Dust Filter protects the pump against abrasive dust.
7.4.4 Inlet Desiccant Trap
Use a Desiccant Trap when you pump limited quantities of water vapour at high pumping speeds to a low
vapour pressure.
7.4.5 Inlet Chemical Trap
The Inlet Chemical Trap protects the pump against chemically active gases.
7.4.6 Outlet Mist Filter
The Outlet Mist Filter separates and traps oil droplets in the pump outlet to prevent oil mist discharge.
The Mist Filter is supplied with an adaptor to connect it to the pump outlet.
Accessory Item Number
ITO20K Inlet Catchpot
ITF20K Inlet Dust Filter
ITD20K Inlet Desiccant Trap
ITC20K Inlet Chemical Trap
EMF20 Outlet Mist Filter A441-10-000
A442-15-000
A445-10-000
A444-10-000
A462-29-000
PV25EK Valve: 200/240 V, 1-phase, 50/60 Hz
PV25EK Valve: 110/127 V, 1-phase, 50/60 Hz
FL20K Foreline Trap
Vibration Isolators (pack of four)
ODE
1
/
4
Oil Drain Extension
C413-01-000
C413-03-000
A133-05-000
A248-01-412
A505-03-000
Pump Inlet Adaptor
Flexible Bellows
Pump Outlet Adaptor
Gas Ballast Banjo Elbow Assembly
Gas Ballast Valve: 110 V, 50/60 Hz
Gas Ballast Valve: 240 V, 50/60 Hz C105-20-201
C105-14-670
C105-01-414
A500-06-003
A500-06-984
A500-06-930
Table 11 – Accessory Item Numbers