bObsweep PetHair WP460011, Owner'S Manual, Page: 84 / 108

84
Step One: Edge Sensors
Right after Bob enters checkup mode and while Bob is on the floor, look at his screen.
You should see four lights indicating TROUBLE NR, MIN CLEANING, CAPACITY, and
CHARGING lit up in the center of Bob’s display.
If all four lights do not turn ON, flip Bob over and clean his edge sensors. Check again
to see if all four lights turn on.
Lift Bob about 6 inches (15 cm) off the ground. You should see the 4 lights turn off.
Put Bob back on the floor.
TROUBLE NR.
CAPACITY
MIN. CLEANING
CHARGING
Do not press any additional buttons. Continue to the next step.