Bobrick B-165 SERIES Technical Data Download Page 2

The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. 

B-165 Rev. 2/2/11

 R/B

     Printed 

in 

U.S.A.

The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. 

© 2011 by Bobrick Washroom Equipment, Inc.

Initial

Position

Approx. 1"

(25mm)

Final

Position

S

S

C

L

Approx. 1"

(25mm)

S

S

C

L

T

T

Initial

Position

Final

Position

INSTALLATION:

Mount wall hanger on wall with screws (not furnished) at points indicated by an 

S

. For plaster or dry wall construction, 

provide backing to comply with local building codes, then secure wall hanger with screws (not furnished) . When providing 
a concealed backing, allow backing to cover minimum range of mounting hole locations shown on drawing.  For other wall 
surfaces, provide fiber plugs or expansion shields for use with screws (not furnished), or provide 1/8" (3mm) toggle bolts or 
expansion bolts. Hang mirror on wall hanger with all four backplate louvers engaged behind horizontal wall hanger members. 
Hang mirror on wall hanger with all four backplate louvers engaged behind horizontal wall hanger members. To do this, 
mirror must be centered in front of the wall hanger horizontally, pressed flat against the wall approximately 1" (25mm) above 
final position and then lowered into final position.

Snap Locking Design

 — Locking devices automatically secure mirror to concealed wall hanger when it is lowered into final 

position. Locking devices may be unlocked by inserting two flat blade screwdrivers behind each side of mirror near the bottom 
or under the bottom of the mirror and pulling mirror bottom forward and then up (see figure 3).

Screw Locking Design

 — Lock mirror to wall hanger by tightening Phillips-head locking screws that are concealed in the 

bottom of frame at points indicated by a 

T

.  Mirror may be unlocked from wall hanger by loosening locking screws and lifting 

mirror off of concealed wall hanger (see figure 4).

SPECIFICATION:

Mirror shall have a one-piece type-430 stainless steel channel frame, 1/2" x 1/2" x 3/8" (13 x 13 x 9.5mm), with 90

°

 mitered 

corners; all exposed surfaces shall have bright polished finish. Select float glass mirror shall be guaranteed for 15 years against 
silver spoilage. Corners shall be protected by friction-absorbing filler strips and the back shall be protected by full-size, shock-
absorbing, water-resis tant, nonabrasive, 3/16" (5mm) thick polyethylene padding. Galvanized steel back shall have integral 
horizontal hanging brackets located at top and bottom for mounting on concealed rectangular wall hanger to prevent the mirror 
from pulling away from the wall. Locking devices secure mirror to concealed wall hanger. Mirror shall be removable from the 
wall. 

Framed Mirror shall be Model B-165 _______________ (insert width and height) of Bobrick Washroom Equipment, 
Inc., Clifton Park, New York; Jackson, Tennessee; Los Angeles, California; Bobrick Washroom Equipment 
Company, Scarborough, Ontario; Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick Washroom 
Equipment Limited, United Kingdom.

Figure: 3

Figure: 4

SNAP LOCKING DESIGN

(Front View)

SCREW LOCKING DESIGN

(Front View)

QA020211

Reviews: