Electrical safety
1. The device may only be connected to a socket that is correctly installed and grounded.
2. The fuse must be a residual current circuit-breaker with a measured residual current of no more
than 30 mA.
3. Always ensure that electrical socket being used has the correct voltage according to the input
power appliance. Socket must also be suitable for equipment with a power consumption of 230V.
4. Make sure that the power supply corresponds with the connection specifications of the device
before it is connected.
5. The tool may only be used within the specified limitations for voltage and power.
6. Do not touch the mains plug with wet hands! Always pull out the mains plug at the plug and not
by the cable.
7. Do not bend, crush, pull or drive over the power cable, protect from sharp edges, oil and heat.
8. Do not lift the device using the cable or use the cable for purposes other than intended.
9. Check the plug and cable be fore each use.
10.If the power cable is damaged immediately disconnect the plug. Never use the device if the
power cable is damaged.
11. If the device is not in use make sure the plug is pulled out.
12.Make sure that the device is switched off before plugging in the mains cable. 13.Make sure that
the device is switched off before unplugging it.
13.Disconnect the power supply before transporting the device.
14.If the power connection cable of this device is damaged, it must be replaced by the manufacturer
or the manufacturer’s customer service department or a similarly qualified person in order to
prevent risks.
15.Need to have a complete and reliable power cord plug, not allowed to insert the wires into the
socked directly, as to prevent the plugging of the plugs from causing electrification of the
electrical enclosure and causing a casualty.
16.Need to check if there is any leakage after power up.
17. Need to check if the capacity of the socket meets the requirements before use.
18.Cut off the power and do not rubbed the wire by hand when move the device.
19.If a flare up occurs, do not use water to put out fire. Turn grill to off. Unplug power cord and wait
for grill to cool.
20.Before all work on the device, always disconnect the mains plug. The grill body must not be
immersed in water.
21.To protect against electrical shock, do not immerse plug, cord or heating element controller in
water or any other liquid.
22.Keep plug and cord dry when in use.
23.Do not use the device outside when raining.
GB
