7 |
P a g e
Cherry 180W Mono Block Amplifier Specifications
Number of Line Inputs
1
Input impedance
100 k ohms
Input Stage
12AX7 current sourced long tailed balanced pair
Pre-driver Stage
12AT7 current sourced long tailed balanced pair
Automatic DC Restoration
6AL5
Nominal Voltage Gain
30 dB (into 8 ohms)
Output Stage Configuration
3 complimentary sets of KT88s in a push-pull configuration (6 total)
Regulated Screen Supply Voltage
360V
Output tube plate voltage
725V
Output tube Idle Power
Less than 10W each
Bias Adjustment
Rear panel pot, front panel meter, set and forget
Rated Power
200 watts into 8 ohms, 230 watts into four ohms, 215 watts into
two ohms
Noise
Better than 110 dB A Weighted referenced into 180 watts
Hum
-100 dB
Frequency Response
2 Hz to 85 kHz. (-3dB)
Full Power Bandwidth
24 Hz to 28 kHz. Without filters
Feedback Control Switch
20dB for Classic Amplifier Sound
11 dB for Contemporary Amplifier Sound
Distortion
Less than 0.5%
Output Transformer
Interleaved windings, super wideband low leakage inductance design
Output Impedance
1.3 ohms
Speaker outputs
2, 4, and 8 ohm terminals
Built in Output Tube tester
Yes
Construction Method
Point-to-Point hand wired axial and radial leaded components with
star grounds and no circuit board traces or de-plugable connectors.
Components
High reliability wire wound and metal film resistors
Metal polyester capacitors in the audio signal paths
Dimensions
14” long by 12.5” wide by 7.2” tall
Weight
84 pounds (38 kg) for a stereo pair, 42 pounds (19 kg) each
Color
Cherry Red with Champaign Trim
Country of Origin:
United States of America
Warranty:
Chassis - 7 Years, Tubes – 1 Year
