BNF Blade Fusion 270, Instruction Manual

Page: 18 / 25

18
EN
Swashplate Cyclic Gain: Centered
Swashplate Direct Feed Forward: Centered
Tail Dynamic: Centered
Remote Gyro Gain
Normal 65%
Stunt 1 55%
Stunt 2 50%
Hold 65%
Optional AR7210BX Setup (ARF version)
The following table provides the settings for the Spektrum ™ AR7210BX DSMX ® Flybarless Control System when used in
conjunction with Spektrum
™
H3050 and H3060 digital servos.
NOTICE: Always follow the manual included with the fl ight controller to perform a Factory Reset of the AR7210BX prior
to beginning a new model setup.
Complete the Control Tests section to verify the controls are responding correctly prior to attempting fl ight.
PARAMETER MENU
(Menu-LED is fl ashing quickly)
OFF
Purple
Flashing
Purple
Solid
Red Flashing
Red
Solid
Blue
Flashing
Blue
Solid
A Cyclic and rudder trim/SAFE
®
trim
Use aileron and elevator stick to trim, hold button 2s to trim rudder. Reset all by rudder stick input.
Switch trim mode by activating SAFE
®
technology using the SAFE
®
switch channel.
B Control Behavior transmitter
C Swashplate – Pitching up behavior medium*
D Tail – Rate Consistency medium*
E Stick deadband small*
F Tail – RevoMIX off*
G Cyclic response normal*
H Pitch boost off*
I RPM Governor – Throttle response slightly increased
J RPM Governor – Initial spool up rate 200 RPM/s
K RPM Governor – Quick change rate 500 RPM/s
SETUP MENU
(Menu-LED is steady ON )
OFF
Purple
Flashing
Purple
Solid
Red
Flashing
Red
Solid
Blue
Flashing
Blue
Solid
Red/
Blue
A Mounting orientation
horizontal
socket, back
B
Swashplate –
servo frequency
200 Hz
C
Rudder –
center position pulse length
1520 μs*
D Rudder – servo frequency 333 Hz
E Rudder – servo endpoints Use rudder stick to move servo to right endpoint and wait, then left endpoint and wait (or vice versa)
F Rudder – sensor direction reversed
G
Swashplate –
servo centering
reference
position
CH1 center
position
CH2 center
position
CH3 center
position
H Swashplate – mixer 120°*
I
Swashplate –
servo directions
nor | nor |
nor
J
Swashplate –
cyclic pitch geometry
Use aileron stick to adjust 6° cyclic pitch on the roll axis to one direction (blades aligned with fuselage)
K
Collective pitch range &
endpoints Set collective stick to max/min position and use aileron stick to adjust desired pitch.
Set pitch direction by rudder stick input: Status-LED blue = positive pitch, red = negative pitch
L Swashplate – cyclic limit Move aileron, elevator and throttle stick. Adjust maximum limit by rudder stick input
M
Swashplate –
sensor directions
nor | nor*
N
RPM Governor –
Operation mode
deactivated*
*Factory setting