Back View of CS2
Mains Cable
Back View of Heater
Switch link Cable - Use
1.5mm² 4 Core Cable
(see note above)
5. CONNECTING A CS-2 CONTROL SWITCH TO THE HEATER
CS-2 control switch box can be easily connected to the HN2-3000G Heater. This will allow the heater to be operated with one or two lamps so
controlling the heat output.
Please make sure you have read the Safety instructions and that you are a suitably qualified electrician before continuing.
Drawings show connections inside the terminal box on the outside of the heater and the inside of the CS2 Controller.
Please Note:- Specified cable sizes are for typical installations, correction factors may need to be used when determining actual cable sizes.
Follow the following instructions to connect the heater to CS-2 Switch Box
a) Open terminal box on back of heater.
b) Remove blanking plug in the heater connecting box and fit cable gland to suit cable you are using (not supplied).
c) Remove Brown Link cable between L - L1 and L1 - L2.
d) Use 4 core silicon cable having a temperature rating of 180ºC or other suitable cable that will withstand 85ºC continuously.
e) Connect the cable as per drawings below.
f) Switch box CS2 MUST be earthed.
6. CONNECTING CS-2 CONTROL SWITCH TO MULTI HEATERS
Using the CS2 switch unit 2 or more 2 Lamp Heaters may be connected as per wiring diagram below.
If you require further technical help on multi-heater connection please contact us using the number on the back page.
