Products that make money, save money and add value to your bottom line
Page • 4
BENDING ANGLES CAN BE PRESET
1. Set the angle setter to 135° then tighten the
right angle stopper to lock the 135° position.
2. Set the angle setter to 90° then tighten the left
angle stopper to lockthe 90° position.
3. Set the angle setter to 135°. Push the operation
button to make your first bend.
4. Slide the rebar to the desired length and set the
angle setter to 90°. Push the operation button to
complete your second bend.
For stirrups, cut your rebar to the desired length
before bending. Then make both bends for your
turndowns. Finally make your (3) 90° bends to con-
nect your ends together. See chart (below)
WARNING: Never touch any moving parts or roll-
ers while the rebar bender is being operated.
INSPECTION AND MAINTENANCE
WARNING: ALWAYS UNPLUG TOOL
BEFORE PERFORMING MAINTENANCE.
DO NOT USE PARTS OR ACCESSORIES THAT
ARE NOT GENUINE DIAMOND BRAND
FROM: BN PRODUCTS-USA, LLC.
At least once a month remove the bottom plate and
grease all the visible gears and pinions. At the same
time, check the carbon brushes for wear or damage.
Replace with new brushes if they are worn out.
(wear limit→replace carbon brushes)
1. Check that there are no loose nuts and bolts
before starting the operation.
2. After operation is completed, be sure to remove
metal dust, dirt, oil, etc… adhering to the ma-
chine surface.
3. In order to empty the metal dust from the
bender, remove side cover (DBD-25X and
DBD-32X models) then tilt the machine to one
side allowing the debris to fall out of the catch
pan. Be sure to blow out any remaining dirt
and dust with compressed air prior to using the
tool again (wear safety goggles to block blowing
debris).
CUSTOMER SERVICE:
(800) 992-3833
