Page | 8
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS — This manual contains important safety and operating
instructions for battery charger. Before using battery charger, read all instructions and
cautionary markings on (1) battery charger, (2) battery, and (3) product using battery.
CAUTION — To reduce risk of injury, charge only BN Products-
USA rechargeable batteries marked on the charger label. Other
types of batteries may burst causing personal injury and damage.
•
Non-rechargeable batteries cannot be charged with this battery
charger.
•
Use a power source with the voltage specified on the nameplate
of the charger.
•
Do not charge the battery cartridge in presence of flammable liquids or gases.
•
Do not expose charger to rain or snow.
•
Never carry charger by cord or yank it to disconnect from receptacle.
•
After charging or before attempting any maintenance or cleaning, unplug the charger
from the power source. Pull by plug rather than cord whenever disconnecting charger.
•
Make sure cord is located so that it will not be stepped on, tripped over, or otherwise
subjected to damage or stress.
•
Do not operate charger with damaged cord or plug. If the cord or plug is damaged, ask
BN Products-USA authorized service center to replace it in order to avoid a hazard.
•
Do not operate or disassemble charger if it has received a sharp blow, been dropped,
or otherwise damaged in any way; take it to a qualified serviceman. Incorrect use or
reassembly may result in a risk of electric shock or fire.
•
The battery charger is not intended for use by young children without supervision.
•
Young children should be supervised to ensure that they do not play with the battery
charger.
•
Do not charge battery cartridge when room temperature is BELOW 10°C (50°F) or
ABOVE 40°C (104°F). When the battery temperature is under 0°C (32°F), charging
may not start.
•
Do not attempt to use a step-up transformer, an engine generator or DC power recep-
tacle.
•
Do not allow anything to cover or clog the charger vents.
Abnormal Display Mode Function
In case of abnormal mode during operation, the remaining amount display LED light
shows the current status of the tool as shown n next page.
LED operation automatically turns off after 10 seconds.
Summary of Contents for BNCE-20-24V SN
Page 13: ...Page 13 Exploded View ...
