0.2
9/12
OPERATION
SAFETY ADVICE
Only use a battery that has been approved for
use in your e-bike. Check if the battery and
housing are intact before use.
Turn off the battery before inserting or removing
it. Check if the battery is properly locked in place
and securely attached before each ride. Chapter
2.1 and 4 contain detailed safety advice on the
use and transportation of the battery.
SWITCHING ON
Shortly press the power button to switch on the
battery. LEDs will sequentially light up and go out
again.
CHARGING
Only use the charger that was supplied with your
e-bike.
Follow the operating manual of the charger.
After connecting the battery to the
charger, the charger might blink red up
to five times. Then the LED display
changes to green and charging
begins.
LEDs change to solid green as charging
progresses:
LED 1, 2, 3, 4, 5
State of Charge
0
…19
%
20
…39
%
40
…59
%
60
…79
%
80
…99
%
100
%
STATE OF CHARGE IN PERCENTAGE
SWITCHING OFF
To switch off the battery keep power button
pressed until all LEDs have turned off.
Battery will turn off automatically if not in use.
TROUBLESHOOTING
Problem
Possible Solution
All LEDs are
blinking
Battery is damaged.
Contact your vendor.
First LED blinks
Battery is empty. Charge
battery.
Mechanical
defect
Check-up by vendor.
Battery does not
work.
Contact your vendor.
CLEANING
If necessary, clean latch and lightly apply bike
chain lubricant spray.
If necessary, clean battery with dry and clean
cloth.
Keep battery contacts and sockets clean. Wipe
with clean and dry cloth, if necessary.
i
