BMW X5 xDrive45e PLUG-IN HYBRID 2022, Owner'S Manual

Page: 374 / 444

system needs to be actively reset. The system
will then take over the actual tire inflation pres-
sures as the target pressures.
When operating the system, also note the in-
formation found in the Tire inflation pressure
chapter.
Additional information:
Tire inflation pressure, refer to page
359 .
Safety information
Warning
The display of the target pressures is not
a substitute for the tire inflation pressure de-
tails on the vehicle. Incorrect entries in the
tire settings can lead to incorrect target tire
inflation pressure values. In this case, it can-
not be guaranteed that the notification of a
tire pressure loss will be reliable. There is a
risk of injury and risk of damage to property.
Ensure that the tire sizes of the mounted tires
are displayed correctly and match the details
on the tires and on the vehicle.
Functional requirements
The following prerequisites must be met for
the system; otherwise, reliable notification of a
tire pressure loss is not assured:
▷ Every time a tire or wheel is changed, the
correct details on the mounted tires must
be entered in the tire settings.
▷ The Tire Pressure Monitor does not acti-
vate until after driving for a few minutes:
▷ After a tire or wheel change.
▷ After a reset, for tires with special ap-
proval.
▷ After changing the tire setting.
▷ For tires with special approval:
▷ After a tire or wheel change, a reset was
performed with the correct tire inflation
pressure.
▷ After the tire inflation pressure was ad-
justed to a new value, a reset was per-
formed.
▷ Wheels with wheel electronics.
Tire settings
General information
The tire sizes of the mounted tires can be
gathered from the tire inflation pressure details
on the vehicle or directly on the tires.
The tire details do not need to be re-entered
when the tire pressure is corrected.
For summer and winter tires, the tire details
entered last are stored. After a tire or wheel
change, the settings of the tire sets used last
can be selected.
Changing settings
1. "CAR"
2. "Vehicle status"
3. "Tire Pressure Monitor"
4. "Tire settings"
5. "Tire selection"
6. "Manual"
7. "Tire type"
8. Select the tire type that is mounted on the
rear axle.
For tires with special approval:
"Other tires"
Observe further proceeding in the perform
a reset section.
9. Select the maximum road speed that will be
used with the tires.
10. "Save tire settings"
The measurement of the current tire inflation
pressure is started. The measurement prog-
ress is displayed.
Seite 374
MOBILITY Wheels and tires
374
Online Edition for Part no. 01405A604A9 - VI/22