BMW X33.0i, Owner'S Manual

Page: 70 / 136

Practical interi
or
acc
ess
orie
s
68
Practical interior accessories
Integrated universal remote
control*
The concept
The integrated universal remote control can
replace as many as three hand-held transmit-
ters for various remote-controlled accessories,
such as door openers and house alarm sys-
tems. The integrated universal remote control
recognizes and learns the transmitted signal of
each of the original hand-held transmitters.
The signal of an original hand-held transmitter
can be programmed on one of the three mem-
ory buttons
1 . Then, the programmed memory
button 1 can operate the device whenever the
ignition is switched on. The LED 2 indicates
transmission of the signal.
Should you sell your vehicle one day, be sure to
delete the stored programs beforehand for your
security, refer to page
69 .
To prevent possible damage or injury,
before programming or using the inte-
grated universal remote control, always inspect
the immediate area to make certain that no peo-
ple, animals or objects are within the travel
range of the device. Also, comply with the
safety precautions of the original hand-held
transmitter.
<
Checking compatibility
If you see this symbol on the packaging
or in the manual supplied with the origi-
nal hand-held transmitter, then it is safe
to assume that the radio-controlled device is
compatible with the integrated universal
remote control.
If you have additional questions, please
ask at your BMW Sports Activity Vehicle
Center or call: 1-800-355-3515.
You can find also information on the Internet at:
www.bmwusa.com or
www.homelink.com.
HomeLink is a registered trademark of
Johnson Controls, Inc.
<
Programming
1 Memory buttons
2 LED
Fixed-code hand-held transmitters
1. Turn the ignition key to position 2.
2. For initial use:
Press both outer buttons
1 for approx.
20 seconds, maintaining pressure until the
LED
2 starts to flash. all stored programs
are deleted.
3. Hold the original hand-held transmitter at a
distance of approx. 2 in/5 cm to 8 in/20 cm
from the memory buttons
1 .
The required distance between the
hand-held transmitter and memory
buttons 1 depends on the relevant system
of the original hand-held transmitter used. <
4. Simultaneously press the transmit button
on the original hand-held transmitter and
the desired memory button
1 of the inte-
grated universal remote control. Initially, the
LED
2 flashes slowly. Release both buttons
as soon as the LED 2 flashes rapidly. If the
LED 2 does not flash rapidly after approx.
15 seconds, then change the distance.
5. To program other original hand-held trans-
mitters, repeat steps 3 and 4.
Online Edition for Part no. 01 41 0 012 863 - © 07/06 BMW AG