Retrofit/Installation Kit no. 82 83 0 022 122 Date: 04.2000
Installation Instructions no. 01 29 0 022 772
Insert hexagon head screw M8x20 (21) from
below into the bracket above (19).
Place the bracket above (19) with inserted
hexagon head screw M8x20 (21) on the
amplifier (1) and screw it in with four fillister
head self-tapping screws 3.5x9.5 (2).
Take note of the positioning of the opening
(40) for the connector of the adapter cable.
!
4.
Install amplifier and supplementary wiring harness (mounting system at
cross brace, only vehicles without on-board monitor radio with battery in the
engine compartment )
1
2
40
21
19
F 46 0718 B
1
19
23
F 46 0719 B
40
42
20
41
F 46 0720 B
Stick on the damping strip (23) as shown, on to
the top of the bracket (19) and the amplifier (1).
The illustration shows the driver's footwell with
view through the opening of the storage
compartment on the left by the side of the
steering column:
Fix pipe clamp (20) to the cross brace (40) of the
I beam.
Cut insulating mat (41) above mounting screw
(42) of the control unit box and screw out
mounting screw (42).
If the Telestart receiver of a retrofitted park
heating is installed at this position, this will have
to be dismantled first.
EN/36
Screw bottom bracket (18) with existing mounting
screw (40) of the control unit box into the drilled
hole (41) provided.
Do not screw mounting screw (40) in tight
as otherwise it will be difficult to slide in the
amplifier.
40
41
18
F 46 0721 B
