Stowing the Mobility System
1.
Unscrew the filling hose of the sealant bot‐
tle from the wheel.
2.
Unscrew the compressor connection hose
from the sealant bottle.
3.
Connect the sealant bottle filling hose that
was previously connected to the valve to
the vacant connector on the sealant bottle.
This prevents left-over sealant from escap‐
ing from the bottle.
4.
Wrap the empty sealant bottle in suitable
material to avoid dirtying the cargo area.
5.
Stow the Mobility System back in the vehi‐
cle.
Distributing the sealant
Immediately drive approx. to ensure that the
sealant is evenly distributed in the tire.
Do not exceed a speed of .
Do not drop below if possible.
Correcting the tire inflation pressure
1.
Stop at a suitable location.
2.
Screw the connection hose of the com‐
pressor directly onto the tire valve.
3.
Insert the connector into the power socket
in the vehicle interior.
4.
Correct the tire inflation pressure to
2.5 bar.
▷
Increase pressure: with the ignition
turned on or the engine running, switch
on the compressor.
▷
To reduce the pressure: press the but‐
ton on the compressor.
Continuing the trip
Do not exceed the maximum permissible
speed of 50 mph/80 km/h.
Reinitialize the Flat Tire Monitor, refer to
page
.
Reinitialize the Tire Pressure Monitor, refer to
page
Replace the defective tire and the sealant bot‐
tle of the Mobility System as soon as possible.
Snow chains
Fine-link snow chains
Only certain types of fine-link snow chains
have been tested by the manufacturer of your
vehicle, classified as road-safe and recom‐
mended.
Consult your service center for more informa‐
tion.
Use
Use only in pairs on the rear wheels, equipped
with the tires of the following size:
255/40 R 19
Follow the chain manufacturer's instructions.
Make sure that the snow chains are always
sufficiently tight. Retighten as needed accord‐
ing to the chain manufacturer's instructions.
Do not initialize the Flat Tire Monitor after
mounting snow chains, as doing so may result
in incorrect readings.
Do not initialize the Tire Pressure Monitor after
mounting snow chains, as doing so may result
in incorrect readings.
When driving with snow chains, if necessary
briefly activate M Dynamic Mode.
Maximum speed with snow chains
Do not exceed a speed of 30 mph/50 km/h
when using snow chains.
Seite 175
Wheels and tires
Mobility
175
Online Edition for Part no. 01 40 2 910 746 - VI/13
Online Edition for Part no. 01 40 2 926 037 - XI/13
