BMW K1200GT, Rider'S Manual, Page: 120 / 172

front wheel with the BMW
Motorrad front-wheel stand.
Fit the front-wheel stand
Place the motorcycle on
centre stand (
83)
Slacken adjusting screws 1 .
Push the two pins 2 apart
until the front suspension
fits between them.
Use locating pins
3 to set
the front wheel stand to the
desired height.
Centre the front wheel stand
relative to the front wheel
and push it against the front
axle.
Push both mounting pins 2
through the triangles of the
brake caliper anchorages
just far enough to allow
the front wheel to be rolled
between them.
There is a risk of dam-
aging the ABS sensor
ring of the BMW Integral ABS.
Push the pin in just far
enough to ensure that it
clears the sensor ring of the
BMW Integral ABS.
Tighten adjusting screws 1 .
If the motorcycle is
raised too far the centre
stand will lift clear of the
ground and the motorcycle
could topple to one side.
When raising the motorcycle,
make sure that the centre
stand remains on the
ground.
Apply uniform pressure to
push the front wheel stand
down and raise the motor-
cycle.
7
118
z Maintenance