BMW K 1600GT, Rider'S Manual

Page: 86 / 209

You can now proceed to log on
all the remote controls.
Step through the following pro-
cedure with each remote con-
trol in turn:
Press and hold down buttons 1
and 2 until LED 3 stops flash-
ing.
LED
3 flashes for about ten
seconds.
Release buttons
1 and 2 .
LED 3 lights up.
Press button 1 or button 2 .
One acoustic signal sounds,
LED
3 goes out.
To complete logon:
Switch off the ignition.
Three acoustic signals sound.
Logon is also ended when
four remote controls have been
logged on.
if you have logged on the first
remote control and then do not
press a button within approxim-
ately 30 seconds.
Synchronise the remote
controls
with central locking system OE
with alarm system (DWA) OE
without Keyless Ride OE
If the central locking system
stops responding to the signals
from a remote control, the unit in
question has to be synchronised.
This can happen, for example, if
the buttons on the remote con-
trol were pressed too frequently
while the remote control was out
of range of the anti-theft alarm.
The procedure for synchron-
ising the remote controls is as
follows:
Switch on the ignition.
Press and hold down buttons 1
and 2 until LED 3 stops flash-
ing.
LED
3 flashes for about ten
seconds.
Release buttons
1 and 2 .
LED 3 lights up.
Press button 1 or button 2 .
LED 3 goes out.
4
84
z Operation