BMW Cevolution, Rider'S Manual

Page: 64 / 156

Frozen relays (device perma-
nently faulty)
Temperature sensor faulty
Fault current test negative
Check the maximum permitted
continuous charge rate of the
wall outlet.
Connect the charging cable 2
to the charging socket 1 on
the E-Scooter. Plug in the
charging cable connector and
press until the locking mecha-
nism
3 is engaged.
Observe the charging cable
displays.
The standard charging cable
will automatically carry out all
of the required test steps. If
LED
2 turns green, the test
was successful and charging
will begin. If LED
4 turns red,
the test was not successful
and the charging procedure
cannot begin. The following
test steps will be carried out:
A check will be carried out
to see if there is a protective
ground connection
A check will be carried out to
ensure that the prerequisites
for proper charging are in place
The status displays / fault mes-
sages are listed in the chapter
"Technical Data".
Symbol 1 for the active charg-
ing procedure and the remaining
charging time
2 are displayed.
6
62
z BMW ePOWER