2
© BMW AG, München
01 29 0 401 236
02.2005 (Z/Z)
Installation information
When routing fibre optic cables, make sure the bending radius is no less than 25 mm.
If the specified PIN chambers are occupied, bridges, double crimps or twin-lead terminals must be used.
Ensure that the cables/lines are not kinked or damaged as you install them in the
car. The costs incurred as a result of this will not be reimbursed by BMW AG.
Additional cables/lines that you install must be secured with cable ties.
After the installation work the retrofit must be programmed / coded using SSS (software service station)
via the
CIP
path.
All the figures show LHD cars, proceed accordingly on RHD cars.
Before installing the roof aerial, clean and degrease the adhesion areas with conventional cleaning
products.
To ensure a permanent bond allow the car to stand in an ambient temperature of at least 20 °C for
approx. four hours.
Ordering instructions
The snap-in adapter is not supplied with the retrofit kit and must be ordered separately for the various
telephones (see EPC for part number and documentation).
The template for cars without a roof function centre is not included in the retrofit kit and must be ordered
separately (see EPC for part number and further details).
The roof aerial for cars without SA 606 or SA 609 is not supplied in the retrofit kit and must be ordered
separately (see EPC for part number and details).
List of special equipment
The following special equipment must be taken into consideration when installing the retrofit kit:
SA 606
Business navigation system
SA 609
Professional navigation system
SA 663
BMW Professional radio
Special tools required
00 9 317 Trim wedge
65 2 010, drawing knife kit (only for cars without SA 606 or SA 609)