Retrofit / Installation kit No. 84 64 0 025 816, 84 64 0 026 649 Issue date: 07.2000
Installation instructions No. 01 29 0 025 885
Disconnect branches
C1
,
C2
and
C3
with the
dimension a = 250 mm from the switch module.
Branches
C1
,
C2
and
C3
are no longer required.
Disconnect the blade terminals from branches
C4
and
C5
, blue/white and blue/brown cables.
Fit the remaining four cables on the switch
module
C
with the pin contacts (14) and connect
them to the plug casing (15) as follows:
Cable colour
Pin
white/brown
1
red/white
2
blue/brown
3
blue/white
4
10. To install and connect the wiring harnesses and switch module
C1
C3
C4
C5
C2
C
14
15
a
F 36 0123 M
B4
15
c
b
C6
C7
17
C8
C9
d
F 36 0124 M
b
A1
A2
B1
C12
B10
a
B2
B3
F 36 0113 M
Remove the footwell speaker (d) and disconnect
the connection cables (b and c).
Push the shrink hoses (17) on to branches
C8
and
C9
, yellow/red and yellow/brown cables,
connect branches
C8
and
C9
to the connection
cables (b and c) and insulate them with the
shrink hoses (17).
Connect branches
C6
and
C7
, yellow/white and
yellow/brown cables, to the footwell speaker (d)
and install the footwell speaker (d).
Connect the white 4-pin plug casing (15) on the
switch module
C
to branch B4.
Connect branches
B10
and
C12
to the earth
post X18723 (b).
Disconnect the plug connector X322 (a) and
connect it to branches
B2
and
B3
. Connect
branches
B1
and
A1
.
Tie back the switch module C behind the foo-
trest with cable ties and install the bottom A pil-
lar trim.
Branch
A2
is not required – tie it back on the
wiring harness.
EN/34