EN/13
Retrofit / Installation kit No. 66 20 0 007 031
Installation Instructions No. 01 29 0 137 628
Issue date: 02.2002
8.
To assemble the car
Assemble the car again following the instructions for its dismantling in reverse order.
9.
Coding
To ensure that the PDC retrofit system adjusts to the specific car perfectly the PDC control
module must be coded. The Mobile Diagnostic Computer MoDIC (III) or the DIS with CD version
15 (or higher) is required to code the PDC control module. It cannot be coded with an older
version.
The steps for this procedure are described briefly below:
Connect MoDiC (III) to the diagnostics plug in the car and switch on the ignition.
Ensure that there is sufficient battery voltage during the coding procedure, connect a
battery charger if necessary.
"
Select menu point
“Coding/Program.”
After completing the coding switch off the ignition for approx. 10 seconds.
"
“Coding ZCS”
<Enter>
“Coding via central coding key (ZCS)”
Version C15.0
(or higher)
<Enter>
Select
“Series E46“
<Enter>
“Retrofit”
<Enter>
“PDC”
<Enter>
“Automatic coding”
<Yes>
