113
Practical interior accessories
Integrated universal remote
control*
The concept
The integrated universal remote control
replaces up to three different hand-held trans-
mitters for various items of radio-controlled
equipment such as door openers and house
alarm systems. The integrated universal remote
control registers and stores signals from the
original hand-held transmitters.
The signal of an original hand-held transmitter
can be programmed on one of the three mem-
ory buttons
1
. After this, the programmed
memory button
1
will operate the system in
question. The LED
2
flashes to confirm trans-
mission of the signal.
If you sell your vehicle one day, delete the saved
programs beforehand for your own security,
refer to page
.
To prevent possible damage or injury,
before programming or using the inte-
grated universal remote control, always inspect
the immediate area to make certain that no peo-
ple, animals or objects are within the travel
range of the device. Also, comply with the
safety precautions of the original hand-held
transmitter.
<
Checking compatibility
If you see this symbol on the packaging
or in the manual supplied with the orig-
inal hand-held transmitter, it is safe to
assume that it is compatible with the integrated
universal remote control.
If you have additional questions, please
contact your BMW center or call:
1-800-355-3515.
Information is also provided on the Internet at:
www.bmwusa.com or
www.homelink.com.
HomeLink is a registered trademark of
Johnson Controls, Inc.
<
Programming
1
Memory buttons
2
LED
Fixed-code hand-held transmitters
1.
Switch on ignition, refer to page
2.
When using for the first time: press both
outer memory buttons
1
for approx. 20 sec-
onds until the LED
2
flashes. All stored pro-
grams are deleted.
3.
Hold the original hand-held transmitter at a
distance of approx. 2 in/5 cm to 8 in/20 cm
from the memory buttons
1
.
The required distance between the
hand-held transmitter and the mem-
ory buttons
1
depends on the particular
system of the original hand-held transmitter
used.
<
4.
Simultaneously press the transmit key on
the original hand-held transmitter and the
desired memory button
1
on the integrated
universal remote control. The LED
2
flashes
slowly at first. As soon as the LED
2
flashes
rapidly, release both buttons. If the LED
2
does not flash rapidly after approx. 15 sec-
onds, alter the distance.
5.
To program other original hand-held trans-
mitters, repeat steps 3 and 4.
The corresponding memory button
1
is now
programmed with the signal of the original
hand-held transmitter.
You can operate the device when the engine is
running or when the ignition is switched on.
Online Edition for Part no. 01 41 0 012 832 - © 08/06 BMW AG
Online Edition for Part no. 01 41 0 012 832 - © 08/06 BMW AG