BMW Motorrad S 1000 R 2020, Rider'S Manual

Page: 46 / 286

40 DISPLAYS
begin until the following mini-
mum speed is exceeded for the
first time:
RDC sensor is not active
min 19 mph (min 30 km/h)
(The RDC sensor transmits
its signal to the vehicle only
once the minimum speed has
been exceeded.)
The tire pressures
are shown in the TFT
display with temperature
compensation and are always
based on the following tire
air temperature:
68 °F (20 °C)
If the tire icon appears
yellow or red at the same
time, the display is a warning.
The pressure differential is
highlighted with an exclama-
tion mark of the same color.
If the level concerned is
borderline in terms of the
permissible tolerance, the gen-
eral warning light also lights up
yellow.
If the monitored tire pres-
sure is outside the speci-
fied range, the general warning
light will flash red.
For further information about
the BMW Motorrad tire pres-
sure control (TPC), see the
Technology in detail ( 165)
chapter.
Tire pressure is at limit of
approved range
with tire pressure monitor
(TPM) OE
lights up yellow.
is displayed in yellow.
Tire pressure not at
setpoint. Check tire
pressure.
Possible cause:
The measured tire pressure is
within the limit range of the
permissible tolerance.
Correct the tire pressure.
Before adjusting the tire pres-
sure, check the information
on temperature compensation
and tire pressure adjustment
in the Technology in detail
chapter:
Temperature compensation
( 166)
Tire pressure adjustment
( 166)
The target tire pressures can
be found in the following lo-
cations: