BMW Motorrad R 1200GS Adventure 2016, Rider'S Manual

Page: 110 / 219

ASC
The front wheel lift assistant is
active in all riding modes.
In RAIN, ROAD and DYNAMIC
riding modes, ASC is set to
road operation.
In Enduro and Enduro Pro rid-
ing modes, ASC is set to off-
road operation.
with Dynamic ESA
OE
Dynamic ESA
In RAIN, ROAD and DYNAMIC
riding modes, HARD, NORMAL
and SOFT damping variants
are available for selection.
RAIN mode default setting:
SOFT
ROAD mode default setting:
NORMAL
DYNAMIC mode default set-
ting: HARD
In Enduro and Enduro Pro rid-
ing modes, HARD and SOFT
damping variants are available
for selection.
Enduro mode default setting:
SOFT
Enduro Pro mode default set-
ting: HARD
Changing setting
The riding modes can only be
changed while driving under the
following condition:
No drive torque at rear wheel.
No brake pressure in the brak-
ing system.
This operating mode is active
when the motorcycle is stopped
with the ignition switched ON. As
an alternative, the following steps
must be carried out:
Turn throttle grip back.
Do not actuate brake lever.
Actuate clutch.
First the desired riding mode is
preselected. The new selection
is not activated until the specified
conditions are present in all af-
fected systems.
The selection menu does not
disappear in the display until the
riding mode has been switched
over.
Tire pressure control
(TPC/RDC)
with Tire Pressure Control
(TPC/RDC)
OE
Operation
A sensor located in each tire
monitors the air temperature and
the inflation pressure inside the
tire and transmits this information
to the control unit.
The sensors are equipped with
a centrifugal controller, which
does not enable the transmis-
sion of the measured values until
after a speed of approx. 18 mph
7
108
z Technology in detail
ProCarManuals.com