Chapter 4: Operating the Equipment
Reference Guide: CT2020
Page 28
November 10
3.17 Status* (19)
This sub-menu displays the actual Status
N.B. This menu is reachable through menu point 14 (Software) and after that and
while the unit is switched on remains visible however if power is removed for any
reason please go back to menu point 14 and repeat the procedure to reach menu
point 15 again.
To enable the Status Menu:
Please go to the Menu-point “Software“ (14)
Next press Enter-Button for 2 seconds. After 2 seconds release Enter-Button and
press Up-Button (arrow up), you have now reached the special “Status” menu.
3.18 Encoder FW* (20)
N.B. This menu is reachable through menu point 14 (Software) and after that and
while the unit is switched on remains visible however if power is removed for any
reason please go back to menu point 14 and repeat the procedure to reach menu
point 16 again.
The complete transmitter performance can be influenced with the changing of the
Firmware. Here, the choice of “HI QUALITY” will give you the best picture quality
however with a slight penalty on the latency side and on the other side the choice of
“HIGH SPEED” will give the optimum latency, however with a penalty on the picture
quality.
Please be aware: When this setting is changed the transmitter must be completely re-
started. This is achieved by separating the transmitter from the power supply. Please
wait 10 seconds before connecting the transmitter back to the power supply. Because
new Firmware has been loaded a 5 minute re-boot is required. A % table indicates the
re-boot status.
