BMPRO RVView2, Owner'S Manual

Page: 14 / 20

14
FAQS AND TROUBLESHOOTING
Need more help troubleshooting your RVView2?
Refer to our website for more information at teambmpro.com/technical-support
Why has the RVView2 screen turned off?
The RVView2 receives power to run the monitor from the BatteryPlus35-II. If the
BatteryPlus35-II shuts power to the monitor, the RVView2 screen will turn off. The
BatteryPlus35-II will shut power to the RVView2 if:
1. The user activated the remote switch connected to the BatteryPlus35-II. This turns
off power to the data cable connecting the RVView2 and BatteryPlus35-II.
Check that the switch has not been activated.
2. The BatteryPlus35-II has entered Storage Mode and to conserve remaining battery
voltage will disable power to the RVView2.
To repower the RVView2, plug the BatteryPlus35-II to a power source and begin
battery charging. When the battery is sufficiently charged, the BatteryPlus35-II will
enable power to the RVView2.
Why is the input/output current showing as 0.0A when there is an active current?
The RVView2 can only display input or output figures of 0.5A or higher. If the level of
current is lower than 0.5A, the RVView2 will display 0.0A.
My BatteryPlus35-II should be charging but there is no charging indicator on the
RVView2?
The charging indicator will only appear if the charging current to the battery is 1.0A or
higher.
If you have BMPRO’s BC300 + CommLink installed, check that it is wired correctly.
Why are four water tanks displaying on the RVView2 when I don’t have four
connected?
The RVView2 will always display four water tanks. If a tank is not connected, it will show
a tank with one segement full, the same as if a tank was connected that is either empty
or less than one-quarter full.