BMPRO ProSmart, Owner'S Manual

Page: 30 / 52

30
4.
Return the tank to its upright position.
Ensure the tank is on a flat and level surface, or is otherwise level with ground.
Even a slight tilt can degrade the quality of the measurement. After a few
seconds, up to a few minutes, the propane will settle and the readings will
stabilise.
Installing SmartSense Sensors
INSTALLING SMARTSENSE SENSORS
To install a SmartSense sensor:
1. On the propane gas tank, ensure the base is clean. Remove any debris,
excess paint or rust.
2.
Using the supplied grease, apply a generous amount to the rubber pads on
the back of the sensor.
3.
The sensor mounts to the base of the tank using magnets. The rubber
pad between the magnets must make good contact with the tank, with no
contaminants in between and must be aligned to the center of the tank.
8.
If this is the first time this sensor has been synced, press the orange sync
button on the SmartSense sensor 6 times. This permanently disables Sleep
Mode, which is the factory setting. After the first use, only a single press is
required to sync the sensor.
9.
Once pairing is successful, the sensor will appear on the Home screen.
More information https://www.caravansplus.com.au