POWERING Y
OUR ADVE
NTURE
S
TEAM
BMPRO
.COM
19 Henderson Rd, Knoxfield, VIC 3180 Australia
Unit 1, 821 E Windsor Ave, Elkhart IN 46514 USA
PAIRING TO THE NODE
Pairing your Controller, smartphone or tablet to the Node is done in two easy
steps.
NOTE:
The Controller will have been paired to your Node at the factory. You
should only need to pair your own device or smartphone to the Node.
While the Node can be paired to a total of four devices (including the
Controller), you can only pair one device at a time to the Node.
1.
Launch the App on your phone.
2.
Press and hold the “Pair” switch that is installed near your Controller for
at least 5 seconds. A spinning circular loading indicator will appear in the
center of the screen and the pairing process will begin. This could take up to
30 seconds.
3.
When pairing is successful, you will be taken to the App home screen and the
Bluetooth icon will be visible.
CONGRATULATIONS, YOU’RE CONNECTED!
For additional support, refer to the
section of your
JAYCOMMAND/TravelLINK Owner’s Manual.
Cannot Pair to the Node
If you are pairing a mobile device to the Node and pairing fails, it is likely that
four devices are connected to the Node simultaneously. To resolve this, close
the app on one of the devices that is connected to the Node and try again.
MOTOR LOCKOUT FEATURE
The system will automatically lockout the motor if a high input is detected on
the brakes. This will be shown on the Node at pin 64.
The motor cannot be turned back on until the lockout is disabled.
If the motor is locked, the App will show a pop-up.
The motor can be turned back on by:
9
Pressing the “Motor unlock” switch installed near your Controller.
9
Sending leveling commands with the leveler.
