30
CARAVAN LOADS
I think one of my loads is not receiving power?
The load may be faulty, activating the protective electronic fuse and turning the
load off. If this is the case, the LED Status Indicator on the ASPower will flash a
solid red.
Should you encounter any faulty loads, please contact your caravan dealership.
None of my loads appear to be powered but I can still use the ASDisplay?
All loads will power down, but the ASDisplay will still be in use if the ASPower
was put into ECO Mode.
The ASPower will be put into ECO Mode if:
1.
The ECO Mode button on the ASDisplay has been pressed. This turns off
power to all caravan loads connected to the ASPower, except output 14.
Check if there is a green LED light next to the ECO Mode button on the
ASDisplay. If there is, press the ECO Mode button again to exit ECO Mode.
2.
Battery voltage is very low. The ASPower will enter ECO Mode to conserve
remaining battery voltage, which will disable power to all caravan loads
connected to the ASPower.
Connect the ASPower to a power source and begin battery charging.
BATTERY
I’ve fitted a battery to the ASPower, but it’s not detected by the ASDisplay?
Check the following:
9
The battery connections are tight and not loose or corroded.
9
Battery polarity: red lead is positive, black lead is negative.
9
The battery fuse on the ASDisplay is fitted and not blown. The correct value
is 40A.
FAQS AND TROUBLESHOOTING
Need more help troubleshooting your ASPero system? Contact our customer
service team online at