BMPRO 033362, Owner'S Manual

Page: 14 / 16

14
TROUBLESHOOTING WITH THE STATUS LIGHT
Need more help troubleshooting your SwayControl? Contact our customer
service team online at
teambmpro.com/technical-support
Status Light
Flash Sequence
Condition or Fault Solution
Solid GREEN
pulsing
Normal operation.
GREEN flash 5
times per second
SwayControl braking is active
1 GREEN flash
every 4 seconds
Module reset to manufacturer
default values. Keep trailer
still for 60 seconds (minimum)
then drive normally.
If module does not return to normal
solid GREEN pulsing light after
3 system restarts, have the unit
checked at a service centre.
Continuous RED,
GREEN flash
Driving on rough terrain
and sway control of trailer is
disabled.
Sway control of trailer is
automatically disabled when driving
on rough terrain. Unit will return
to normal operation (GREEN light)
when not on rough terrain.
No Light Unit in “sleep” mode
Activate manual override on the
brake controller to “wake-up” unit
No Light
No power after “wake-up”
from brake controller
Check quality of power, ground and
brake controller wire connections.
Check for any blown fuses on the
tow vehicle and trailer.
No Light
Over voltage, greater than 20V
detected
Check power source voltage, correct
voltage is 12-15V.
No Light
Low voltage, less than 3V
detected
Check power source voltage, correct
voltage is 12-15V.
Check quality of power and ground
connections.
1 RED flash System malfunction Service centre repair required.
2 RED flashes
Sensor malfunction - no sway
control of trailer
Service centre repair required.
3 RED flashes Left side brake short
Correct the short in left side brake
wiring.
4 RED flashes Right side brake short
Correct the short in right side brake
wiring
Fast RED flashing
Low voltage, between 3 and
6V
Check quality of power and ground
connections.