BMB
e-mo-desk, two engines, 600-1250mm / 700-1200mm
Art.-No. 4884.617, 4884.618, 4884.666, 4884.688,
4884.717, 4884.718, 4884.766, 4884.788
7/10
Press the DOWN button on the handset (part 7) until the base reaches its lowest position.
Measure the height of the base from the floor and if the number on the LED display does NOT match
your measurement, follow these steps:
Press and hold the DOWN button again until the LED display reads "RST". Press and hold the
M button
about 5 seconds until the LED displays the flashing starting height (If the display returns to "RST"
before the next step is taken, repeat this step.).
Use the UP/DOWN buttons to change the value of the starting height so that it matches your measure-
ment. Once the new value is displayed, wait about 5 seconds and the display will return to "RST".
Finish the reset process by pressing and holding the DOWN button again until the desk lowers a little bit
more, slightly rises and stops. Release the button. The new starting height value is saved and your desk
is now ready to use.
Note: the LED display has a ± 0.1 tolerance.
SETTING THE LED RETRACTED HEIGHT
(some models)
PROGRAMMING
(some models)
Press the DOWN button on the handset (part 7) until the base reaches its lowest position.
Press and hold the DOWN button again until the LED display reads "RST". Press and hold the
1 button
(about 5 seconds) while the LED display flashes "RST" and then switches to either:
10.1 = One-Touch
10.2 = Constant-Touch
Release the 1 button. Press the 1 button again until the desired setting is reached. Once the chosen set-
ting is displayed, release the button and wait about 5 seconds for the display to return to "RST".
Finish the reset process by pressing and holding the DOWN button until the desk lowers a little bit more,
slightly rises and stops. Release the button. The new program setting is saved and your desk is now
ready to use.
CHANGING ANTI-COLLISION SENSIVITY
(some models)
Press the DOWN button on the handset (part 7) until the base reaches its lowest position.
Press and hold the DOWN button again until the LED display reads "RST". Press and hold the
UP button
(about 5 seconds) while the LED display flashes "RST" and then switches to either:
10.5 = 10 kg pressure (most sensitive)
10.6 = 15 kg pressure (middle setting)
10.7 = 20 kg pressure (least sensitive)
Release the UP button. Press the UP button again until the desired setting is reached. Once the chosen
setting is displayed, release the button and wait (about 5 seconds) for the display to return to "RST".
Finish the reset process by pressing and holding the DOWN button until the desk lowers a little bit more,
slightly rises and stops. Release the button. The new anti-collision sensivity is saved and your desk is
now ready to use.