BMB MEDICAL – CLAVIA 5 / 1VCLVE092020
94
3
CLEANING
AND
DISINFECTION
3.1
INTRODUCTION
Regular and thorough cleaning will guarantee the device’s life (see cleaning program drawn up
at the time of device commissioning, designating the reference staff).
Failure to perform these cleaning operations can lead to a risk of infection caused by the
presence of secretions and/or residues on the chair.
The following cleaning advice is not intended to replace your establishment’s in-house protocol.
This chair has been designed to facilitate its cleaning thanks to its removable cover.
3.2
FREQUENCY
The chair should be cleaned:
-
Between each patient.
-
After transporting an infected patient.
-
Completely each week
3.3
CLEANING
AND
DISINFECTION
ADVICE
3.3.1
CLEANING OPERATION
Before cleaning the chair, unplug it from the mains and ensure that all internal connections
are correctly established.
For routine cleaning of the upholstery, painted stainless steel or aluminum surfaces, plastic parts
and control elements, a gentle detergent such as soapy water may be used, followed by rinsing
with clear water. After cleaning, dry the product thoroughly.
All of the product’s surfaces must be cleaned.
During cleaning or disinfection, it is recommended to:
-
Spray or apply the cleaning product to the MD with a clean disposable cloth.
-
Start with the areas closest to the patient, focusing on parts in contact with users.
-
Proceed from top to bottom.
-
Allow the equipment to dry.
Products that cause stains (e.g.: “blue product” or eosin) must be cleaned as rapidly as
possible to prevent them from soaking in.
Aerial disinfection of surfaces is allowed for this product.
In the case of a product fitted with a USB charging port, ensure that no liquids enter the port.
