BM2 BIEMMEDUE GEMINI PLUS, Instructions For Use And Maintenance Manual

Page: 37 / 52

USE OF THE MACHINE
Use and Maintenance
15
■
Vacuuming function
- Press button G (with the symbol of the fan)
on
the machine (fig. 9).
- Press button M (fig. 11) on the handle to activate
the vacuuming function, fit the accessory
you wish and start cleaning. To interrupt
vacuuming, press again button
M .
- Adjust steam flow: keep button M pressed for
a few seconds to shift from high from low
flow. By releasing the button
M the selected
flow will be set.
- Once the vacuuming function is deactivated,
next time you use the machine the suction
intensity will return to the maximum value.
■ If the red water indicator light comes on
When the indicator light O turns on and an
intermittent beep sounds, the tank is running
out of water. Therefore the steam flow will be
interrupted.
If the light turns on, proceed as follows:
- Disconnect the machine from the power
supply.
- Remove filler D and fill it completely with
tap
water.
- Restart cclleeaanniinngg..
■ If the dust collecting tank is full
When the maximum level in the dirty water tank
is reached, suction stops and the motor makes a
different noise.
In this case, proceed as follows:
- Disconnect the machine from the
power supply.
- Remove the male plug of the flexible hose from
the machine.
-
Remove the dust collecting tank from
its seat.
-
Pull out hook E (fig. 14) and raise the tank
cover.
-
Empty the tank.
- Fill with water up to the level indicated
inside the tank (white mark).
- Close the cover and reposition the tank on the
machine making sure it is properly placed until
limit stop (otherwise, suction is off).
- Re-connect the plug of the flexible hose to the
machine and restart your work.
Do not remove the dirty water tank before the
vacuum motor has stopped completely.
- Reconnect the machine to the power supply.