Cable Hex Bolt
Clip
Top plate
15
S t e p 1 0
Ro u t e T h e C a b l e
1)Put the clip tied on the weight pin leash onto the Top
Plate(#44) as shown, next connect the Cable(#45) to
the Top Plate(#44).
2)Route the Cable(#45) up and over the two Pulleies A
(#22).then secure them to the Main Upright(#1) using
3)Route the Cable(#45) down and under the Pulley B
(#22),then secure them to the Main Upright(#1) using
4)Connect the looped end of the Cable(#45) to the Cam
(#10), secure it using :
5)Adjust the tension of the Cable(#45) using the Cable
Hex Bolt as shown below.
6)Make sure that the cable is in grooves of all pulleies
then fully tighten all bolts and nuts .
Two Allen Bolts(#60) M10×45
Four Washers(#68)
11× 20×2
wo Nylon Locknuts(#71) M10
One Shoulder Bolt(#59) M10×50
wo Half-pulley Covers(#39)
ne Nylon Locknut(#71) M10
ne Screw(#81) M4
20
T
T
O
O
×
Φ
Φ
A
B