14
Functions of the volumetric keypad
The supply head is provided with a touch screen panel with 4 back-lit commands:
3 commands control the supply of water, 1 controls the programming of the
doses (P.4). All buttons are back-lit and always on.
The supply head is equipped with a VOLUMETRIC dispensing system. The
dispensing quantities are easily PROGRAMMABLE during installation and it’s
possible to set two quantities for each button. On turning on the unit, the default
settings are as follows: a short push of the button dispense 200 cc (a cupful) of
water, whereas a long push dispense 1000 cc (1 litre).
BUTTON FUNCTIONS:
- SPARKLING WATER UPPER DISPENSER button (P.1)
- ROOM-TEMPERATURE WATER UPPER DISPENSER button (P.2)
- COLD WATER UPPER DISPENSER button (P.3)
While the water is being dispensed, the LED turns itself off. You can stop the
dispensing process at any time by pressing the button again.
SETTING THE QUANTITIES:
Thanks to the Volumetric dispensing functionality, you can customize the pre-set
quantities dispensed by each of the 3 buttons. Normally, a SHORT push of the
buttons used for the dispensing of small quantities, with a LONG push being
used for the dispensing of larger quantities. The default settings are 200 cc for a
short push and 1000 cc (1 litre) for a long push.
To enter the programming mode, press and hold (for > 4 seconds) the following
combination of buttons: P.4 + P.2 (Energy Saving “Room temperature”
button). When you enter the programming phase, you will hear three consecutive
beeps.
In this phase, the LEDs of the dispensing buttons start to flash.
To set the maximum dispensing limit for a specific button, press the button in
question to start the dispensing process (the LED of the button turns off). Press
it again once you have reached the desired quantity. To set the short dose, push
the button for a short time; to set the long dose, press it until it starts dispensing
water. When the limit for the button has been set, the corresponding LED stays
on. Repeat the process for the remaining buttons.
To exit from the programming mode, press and hold (for > 4 seconds) the
following combination of buttons: P.4 + P.2 (Energy Saving “Room
temperature” button), save the data and set the new limits.
The maximum settable quantity for each button is around 3,0 litres, which equates
to a 65-second dispensing session.
