Operating Instruction
WARNING:
ALWAYS ACCESS THE CONTROLS AND CYLINDER VALVE FROM THE SIDE OR THE
REAR OF THE HEATER.
DO NOT ATTEMPT TO RE-LIGHT UNTIL 5 MINUTES HAVE ELAPSED.
Light the heater
Open the valve on the gas cylinder.
The control knob must be aligned with the position. Push down fully on the control knob
(this will allow gas to flow from the pilot and the burner). While still holding down the
control knob fully, immediately push the impulse ignition button to light the atmosphere
analyzer (ODS).
If the pilot and one burner do not ignite, release the control knob and spark piezo button,
wait 30 seconds and repeat the procedure.
Once the pilot is lit, continue to hold the knob depressed for further 20 seconds until the
atmosphere analyses remains lit after releasing the knob. Release the control knob and turn
it to the position corresponding to the desired amount of heat
Shut off the heater
•
Turn the control knob to the
position
•
To switch off the equipment, close the valve on the gas cylinder.
•
Do not move the heater when it is operating.
Ignition
Low
High
17
